Microdos - дозирующие насосы - Главная

Перейти к контенту

Главное меню:

насос mp1-speedy ph инструкция
MP1 SPEEDY PH - Peristaltic Pump by Microdos S.r.l.. Peristaltic pump with built in controller.Suitable for acid chemical dosage.Easy calibration process over 6.0 pH trough 8.0 pH interval.Semi-automatic calibration at 7.01 pH value.pH visualization
насос mp1-speedy ph инструкция; pH 7.0 and pH 4.0 solutions are required for calibration. You may also calibrate using pH 7.0 and You may also calibrate using pH 7.0 and pH 10.0 solutions if your readings will normally be higher than 7.0
Peristaltic pump with built in REDOX/ORP controller Suitable to dose oxidizing chemicals Set Point easy calibration between 300-800 mV interval Semi-automatic calibration with buffer 468 mV Set Point proportional dosage ON/OFF function Polycarbonate front panel IP 55 Protection Degree Standard Power Supply 230 Vac PERISTALTIC REDOX PUMP
me1-ph Мембранный насос для контроля РН. Диапазон чтения ph 0-14. me1-rx Мембранный насос для контроля red
Two MP1 Speedy -pH/Rx, dosing pumps with on-board pH/Rx controller Digital display for reading and programming Easy programming and calibration, possible with just two buttons and a digital disppH and Redox (mV) simulator used for checking the calibration of any pH instrument with a conventional pH electrode input. Special circuit to check for loss of impedance on the input. Special circuit to check for loss of impedance on the inp
c 15 по 18 мая 2018 года На Нижегородской ярмарке вы можете посетить нашу экспозицию международной выставки "Чистая вод
 
Copyright 2015. All rights reserved.
Назад к содержимому | Назад к главному меню